Do you need help? Post your question on the forum, there will always be a member to help you and give some advice. Ask a new question
Contribute, 36 messages are still unanswered
HowToDo Question : How RN213 wired controller ?

Waiting for a better solution How RN213 wired controller ?

Forum-> Electronics
Post new topicReply to topic
View previous topic :: View next topic  
Author Message

PostPosted: 02 Dec 2010 1:18 
Hello, I
seeks to use a washing machine motor and its controller BB40 (RN213) to run a notching (it's a machine that grinds the apples to make cider! !)
I wish I could control the speed, so I want to use the controller.
son I have 6 marked

1, 2 Ph, N (well, that, that is) 3 PT

May 1000 (no cable)
6 CN

7 CL
anybody know what that means?
I think send Phase alternately 3, 4, 6, 7 and see what happens, but I say it may need to send several at the same time.

Could someone help me?

I even have the schema, if necessary...
1: Hello, I have doubts about the performance of this engine type for the use you want faire.Il should instead be a more powerful engine

PostPosted: 02 Dec 2010 2:33 
Bonjour,j'ai des doutes sur les performances de ce type de moteur pour l'utilisation que vous voulez en faire.Il faudrai plutot un moteur plus puissant.

PostPosted: 02 Dec 2010 2:45 
Thanks much for your reply.
I too have some doubts, but I'm gone, I'm going to end stuff.
I multiplied to death (x10 ), I hope it'll work.
In fact, I do not want to use that material Recycling, limiting traffic.
So if you still had the answer to my question, I'd be delighted and grateful.
Sincerely ,
Display posts from previous:   
Post new topicReply to topic    HowToDo Forum Index -> Electronics All times are GMT + 2 Hours
Page 1 of 1


Similar topics of the

How to Connect a tachometer electronics ?
What to do with the problem of micro-controller ?
Where touver a diagram of speed controller RC ?

Links suggested by Google