Do you need help? Post your question on the forum, there will always be a member to help you and give some advice. Ask a new question
Contribute, 36 messages are still unanswered
HowToDo Question : How to adjust roller shutter electric wire ?

Waiting for a better solution How to adjust roller shutter electric wire ?

Forum-> Do It Yourself
Post new topicReply to topic
View previous topic :: View next topic  
Author Message
Guest





PostPosted: 01 Dec 2010 14:09 
Hello everyone,

concerns:
> My shutter controlled electric wireline Warranty
Expired.
> Engine unidentifiable without adjusting knobs (+ or -).

State Operating

. The descent of the platform without problems.
. The climb takes place but also with a stop at the top of the race, to 2cm from the top squad, and remaining 2 blades openwork. Meanwhile, the engine purrs and warm after a few minutes.
By cutting the power from the inverter wall, the hum stops.

> My Control Console consists of a small box, not identifiable
(55mm high x 45mm deep). It is clipped in the PVC joinery. Inside this box is clipped a petit'Inverseur: "Top-Off-Low" (30mm x 12mm tall deep) into which 3 only son:
(BLACK = Up/BLUE = Off/Red = Down), down the trunk.
To my surprise, no presence of green (GND).
Yet, all taken from my house
are wired with "earth", and individually connected to a microswitch-
dijonctor on the front dash area of EDF

** How to make an adjustment with this inverter to 3 son,
safe to blow the house down?
Greetings
Guest





PostPosted: 01 Dec 2010 15:53 
Hello

If your component stops a few inches from the top something is blocking the system before the engine has reached its limit.
Try to see inside the box if you have access.

Your order 3 son will probably straight from MECHANISMS component, there must be another cable for power
Guest





PostPosted: 01 Dec 2010 18:23 
Hello, if I summarize your problem, the flap does not fit well mounted, verify that nothing interferes with the passage of blades. If the engine runs while flap is raised without stopping is that he has reached his position triggers its decision
Display posts from previous:   
Post new topicReply to topic    HowToDo Forum Index -> Do It Yourself All times are GMT + 2 Hours
Page 1 of 1




 

Similar topics of the


Links suggested by Google