Do you need help? Post your question on the forum, there will always be a member to help you and give some advice. Ask a new question
Contribute, 36 messages are still unanswered
HowToDo Question : How to change a flush ?

Waiting for a better solution How to change a flush ?

Forum-> Plumbing
Post new topicReply to topic
View previous topic :: View next topic  
Author Message

PostPosted: 29 Nov 2010 11:22 
Hello, I changed my
ancient mechanism with a new toilet with push button.
Everything is installed, I have done well no leaks! !
the only problem and what problem is that at the time of the button, I m'apercoie that the hole in my tank cover is not big enough 13 mm cap 14.
How can I do? there are standard buttons that go on my mechanism or do I enlarge the hole, but how?
thank you for your advice

PostPosted: 29 Nov 2010 13:21 
Good evening,

You can try to break, but with a chignolle hand (crankshaft) or a screw gun battery, provided the turn very slowly and clutch engaged. Otherwise, use a rat tail file and enlarge the hole by hand. There will be laughter, but the ring of the button should hide them.
Good luck

PostPosted: 29 Nov 2010 13:50 
Good evening,

I'll join, ys, on the rat tail, always going down.
And slowly, if the china is hard, it's almost a lost cause!

Good luck !

PostPosted: 29 Nov 2010 15:23 
Good evening,
corundum abrasive paper wrapped tight on rod works too.
Good luck, Daniel

Display posts from previous:   
Post new topicReply to topic    HowToDo Forum Index -> Plumbing All times are GMT + 2 Hours
Page 1 of 1


Similar topics of the

How to have training in plumbing ?
Can we teach plumbing ?
How to adjust a float on a flush ?
How to repair a flush Roca unresponsive ?
How to replace the ball flush griffin ?
How to repair a flush with a button stuck ?
Should I change my faucet ?
Is this the security group and how to change it ?
How to change a valve gasket ?
How do I change my toilet drain ?
How to change the inverter Monoblock bath ?
How do I change my cartridges water filters ?
How to change manual valves with thermostatic ?
Why the change of heating pipes in steel ?
How to change the membrane of a balloon blower ?

Links suggested by Google