Do you need help? Post your question on the forum, there will always be a member to help you and give some advice. Ask a new question
Contribute, 36 messages are still unanswered
HowToDo Question : How to dismantle the security door of my LL ?

A solution has been found How to dismantle the security door of my LL ?

Forum-> Home Appliance Repair
Post new topicReply to topic
View previous topic :: View next topic  
Author Message
Guest





PostPosted: 03 Dec 2010 17:14 
Hello, security door of my washing machine arthur martin disjonter AW 865T is my electric meter.
I can not remove it, thank you for giving me the trick that will allow me to do so.
thank you
Guest





PostPosted: 03 Dec 2010 18:38 
Cette réponse a aidé l'auteur du sujet.
GOOD EVENING
You must defeat both right and left walls, attached to the back with screws, see screw nuts, and then you lift the top for access to the security door, disconnect machine for your safety and your proches.Cordialement Jean-Paul
Guest





PostPosted: 03 Dec 2010 19:20 
Cette réponse a aidé l'auteur du sujet.
Good evening,

must disassemble the cons-Stainless steel door (remove the screw all the way around), but weird whatsoever the safety door, unplug the power cord first.

A + and good luck
Guest





PostPosted: 03 Dec 2010 21:21 
thank you for your answers Jean-Paul and Lachignole, I am finally here.
to meet Lachignole:
the machine blows a fuse when I turn it on.
I unplugged the resistance: such
I unplug the engine: the same and I see a spark at the famous security door.

Now that I managed to get out I measure the continuity between its 3 cards: I find the infinite everywhere ("1" on my tester-esh-2M).
is this possible that the short circuit takes place just when I put the then current or DC is on its power supply wire and then it would be the small box located at the finish of the inside of the machine back side. measurement made on it: it goes down to 200k and it goes back to 600kohms.
what do you think, thank you
Guest





PostPosted: 03 Dec 2010 23:29 
Good evening

the little box after the power cord is a filter, it is not an issue since it is always turned on, the security door might be a leak to ground, normally you should find a resistance ohmmeter 10 20 K ohm between terminals 2 of the 3 door contact is infinite everywhere if the door contact is HS
Guest





PostPosted: 03 Dec 2010 23:58 
Hello, I confirm the answer to Mareson, especially if you see the sparks hs is the change
Guest





PostPosted: 04 Dec 2010 2:18 
and thank you for returning !
Display posts from previous:   
Post new topicReply to topic    HowToDo Forum Index -> Home Appliance Repair All times are GMT + 2 Hours
Page 1 of 1




 

Similar topics of the


How to dismantle an oven door Brandt FP265BF12 ?
How to bypass the Security door washing machine ?
How to reset security door Arthur Martin LL AW2107S ?
Where to find websites on the appliance ?
How to Repair the door of my oven ?
How to repair the door of my microwave ?
How to repair dishwasher door fixing ?
How to repair my oven door Jump ?
How to repair a hole in the freezer door ?
How to repair the door of my washing machine whirlpool ?
How to repair broken door handle innovative Fagor 6kg ?
Why security is warming up ?
How to dismantle a pressure switch ?
Why is the security of seeing my indesit wia 9 flashes ?
How to dismantle an oven NEFF ?

Links suggested by Google