My dishwasher Indesit IDL 552 showed leaks for weeks on a random mid-cycle, but not every time. I saw that the bottom door seal was in poor state. I bought one from a specialty shop (35.sic!). I removed the old. I arrive at the new place, but it takes up 3to seconds then jump. To clarify, the seal has two edges : a board that fits next tank, this one is very good, and the second side to side door.. but insert the stainless steel plate of the door does not stay inserted in the gasket.
The gasket around the door seems in good condition.. if I fail after replacing the gasket at the bottom. I will follow your advice. But for now, joined the tour defective or not I am a bit stupid with the bottom joint which does not take up.
In reading your message, I think to check the length. no particular worries. I did not overlap.
No problem The insert is pretty easy, but it does not stay in his place. Looking closely, I saw that next door, the seal was "pinched" strongly every 5 cm do hold. Pulling to remove it, as I had a feeling that the buttonhole gradually loose. Not having an instrument to realize this fixation, I at once asked the quesion glue