Do you need help? Post your question on the forum, there will always be a member to help you and give some advice. Ask a new question
Contribute, 36 messages are still unanswered
HowToDo Question : How to mount a partition BA13 high ?

A solution has been found How to mount a partition BA13 high ?

Forum-> Construction & Renovation
Post new topicReply to topic
View previous topic :: View next topic  
Author Message
Guest





PostPosted: 01 Dec 2010 11:03 
Hello everyone, and thank you for the help you give me.

Currently redoing our first floor, installation of Velux insulation OK, sanding parquet, pine beams scratching etc..

Epres its festivities, we need to mount partitions.
was thinking plasterboard type BA13, the problem being that the range is 3.8M, and I have a doubt about the rigidity of the transverse bulkhead will be close to 8m long.
there will be 2 perpendicular walls, a base on solid floor, but not too much solution for the high, which is under sloping roof, lined with BA13 rail etc.. we suspected a bit.

So, is there a solution to ensure a good rigidity of the partition, or is that it does not pose particular problem?

taking into account the region where the foehn rages with strength and vigor

thank you to all of the assistance
Guest





PostPosted: 01 Dec 2010 12:46 
Good evening, could you be a little more specific about your concern to the ceiling, because if your ceiling was well done I think it should not be any concern to set your partition it (if you set your rails on your fur with small wedge for offset slope it should not be a problem)

good evening
Guest





PostPosted: 01 Dec 2010 14:23 
Good evening,
A photo would be welcome, to better understand. Anyway, regarding the height, it is advisable to place a reinforcement if it is greater than 2.50m, for proper rigidity.
Is the partition of 8m x 3.8 m, is in the middle of a room, or against a wall ?
Guest





PostPosted: 01 Dec 2010 16:00 
bonnjour

did I understand?

The height of the wall is 3.80m?

I've landed safely with a measure of 5m. the value of 2 floors. It was a mezzanine
Guest





PostPosted: 01 Dec 2010 16:32 
hello

Well here is well underway!

Good luck
!
Guest





PostPosted: 01 Dec 2010 18:56 

hello and good luck for the rest
cordially cristof
Display posts from previous:   
Post new topicReply to topic    HowToDo Forum Index -> Construction & Renovation All times are GMT + 2 Hours
Page 1 of 1




 

Similar topics of the


How to partition into a construction logs ?
How to mount a partition of 7 meters of chipboard 10 ?
How to mount a removable partition to create two rooms ?
How high chimney for an expansion ?
How to renovate a ceiling BA13 ?
How do you partition ?
When to change plates BA13 repellent ?
how to paste the strips between the plates BA13 ?
How to fix a retaining BA13 hardboard ceiling ?
Where to start a renovation ?
How to organize a renovation ?
Why a sustainable renovation ?
Should we prepare walls before laying BA13 plate ?
This semi-renovation is correct ?
What solution to put a temporary partition ?

Links suggested by Google