Do you need help? Post your question on the forum, there will always be a member to help you and give some advice. Ask a new question
Contribute, 36 messages are still unanswered
HowToDo Question : How to pass a water heater to the sorting phase ?

Waiting for a better solution How to pass a water heater to the sorting phase ?

Forum-> Electricity
Post new topicReply to topic
View previous topic :: View next topic  
Author Message
Guest





PostPosted: 30 Nov 2010 7:47 
hello all
after reading this forum, I can not find an answer to my problem so I asked directly
I want to spend my wiring sorting single-phase to
my water heater is currently running in sorting, with a direct connection from the counter (even when protected by fuses) but not through my electrical panel, so I can not connect the switch day/night on this table
my water heater is a horizontal De Dietrich but impossible to find instructions for installation, it is intended for use in mono and there is a three-phase installation kit which happens on my PSU: 3 red only son
how to connect my new single phase power + neutral + earth?
thank you in advance for your answers
Guest





PostPosted: 30 Nov 2010 8:13 
Good evening, 30ma protection with edf and the switch (I/A/O) = neutral repère2
repère4 = phase
the son 2et4 to chauffe_ water.

has +
Guest





PostPosted: 30 Nov 2010 9:04 
Hello

You can place a heater three-phase electric mono
without needing a kit

Just follow the change on the following link

http://www.savoirtoutfaire.com/wiki/images/Branchement-chauffeau.JPG

It will take to rewire the power supply between a phase and neutral

Otherwise if you want to keep the phase you can take a peak pole switch is fairly easy to install.
3..: Hi,
kit, is it the "easytri" with electronic thermostat?
A +
Guest





PostPosted: 30 Nov 2010 9:24 
Bonsoir,
Le kit, est-ce le "easytri" avec thermostat électronique?
A+
Guest





PostPosted: 30 Nov 2010 11:54 
thank you for your answers
with this scheme, I should get out but I do not know where to plug the earth!
otherwise it is not easykit installed but "kittri" which must be older
soon
max
Guest





PostPosted: 30 Nov 2010 14:15 
HELLO
It possible if all three resistors are connected in a star with neutral on the 380 volts from 230 volts phase.En mono, connect the resistors parallèle.Mais there arises the problem of connecting the thermostat.Le safer is consulted before any changes to the wiring diagram supplied with the unit.
Look at the cover you need a wiring diagram for 3 resistors couplage.Si rather, we need a common point for the neutral and how a point for Jean-Paul
Display posts from previous:   
Post new topicReply to topic    HowToDo Forum Index -> Electricity All times are GMT + 2 Hours
Page 1 of 1




 

Similar topics of the


How to pass a single-phase AC motor ?
How to reduce oven amperage single phase three phase network
How to transform a single-phase three-phase generator ?
Can we move from 208V to 240V 3 phase 1 phase ?
Why water heater does not work in peak hours ?
How to change breaker-less water heater switch ?
How to get my counter-phase to single phase ?
Why is the water heater suddenly works that Forced mode ?
Is 20A phase are sufficient for the phase ?
How to connect oil cooler sorting 380 on PC 220 Mono ?
How to convert a fan forging sorting Mono 220v ?
How do my electricity ?
How to teach electricity ?
Should we do make electricity by a pro ?
How to pass son in my plasterboard wall ?

Links suggested by Google