Do you need help? Post your question on the forum, there will always be a member to help you and give some advice. Ask a new question
Contribute, 36 messages are still unanswered
HowToDo Question : How to use a thermostatic valve ?

Waiting for a better solution How to use a thermostatic valve ?

Forum-> Plumbing
Post new topicReply to topic
View previous topic :: View next topic  
Author Message
Guest





PostPosted: 04 Dec 2010 5:04 
Can we feed a thermostatic bath and shower faucet with water cheau valiant atmospheric mag FR11 xzh Thanks for the reply
Guest





PostPosted: 04 Dec 2010 6:05 
Cette réponse a aidé l'auteur du sujet.
Hello,
Unless I am mistaken Your instrument is a cumulus cloud is entirely possible.
The heating apparatus immediate them, pose few problems, compared to Bebits water needed to operate the thermostatic valve, paradoxical to that required for the proper heating of the water. But you're not in this case!
Good day
Guest





PostPosted: 04 Dec 2010 7:51 
I do not know what that means because cumulus with this water heater I have no reservation is direct
Guest





PostPosted: 04 Dec 2010 8:47 
Re
So my mistake, I apologize.
A cumulus, is a "balloon" in which there is a certain amount of water that is heated in the same ball, which is a warm pool. At the exit of the ball, regardless of the flow, water is always at the same temperature, unlike a direct fired unit, where the outlet temperature depends directly flow. Hence the difficulty of setting the tap.
I do research to try to answer you.
A +
Guest





PostPosted: 04 Dec 2010 10:38 
Re
I ' have not found a device that exactly matches your reference and is therefore a little dry. For cons, I confirm my point, namely, a certain incompatibility between thermostatic and direct heating. Some suppliers of thermostatic valves, advocate for proper operation, a heating power of 18kw/h at least! One of the "solutions" could be a thermostatic valve top-end, including the rapid response to temperature is much higher than normal. These have the advantage of smoothing out differences in temperature but low-flow, behave like the others. The big drawback is their price. For my part, I find that the comfort provided, does not justify the cost.
Sorry for not being more assertive
Guest





PostPosted: 04 Dec 2010 12:58 
Hello

2.3 to 2.7 m3/h, there must be an error or it is a very big instrument!

Read ' indication liters/minute
Guest





PostPosted: 04 Dec 2010 15:24 
OK this is the gas flow, so the flow is 11 liters min
Guest





PostPosted: 04 Dec 2010 16:50 
Cette réponse a aidé l'auteur du sujet.
Hello
This does not work properly, there should be a flow of +/- 18 liters and plumbing accordingly
Display posts from previous:   
Post new topicReply to topic    HowToDo Forum Index -> Plumbing All times are GMT + 2 Hours
Page 1 of 1




 

Similar topics of the


How to disassemble a thermostatic valve comap ?
How to disassemble a thermostatic mixing valve ?
Can we teach plumbing ?
How to have training in plumbing ?
How to adjust my mixer Thermostatic ?
How to remove the thermostatic valves ?
How to resolve a leak in a thermostatic mixer ?
Where can I find a thermostatic head centralized ?
How to change manual valves with thermostatic ?
How to disassemble thermostatic F. Grohe 2673 ?
The valve is defective ?
What is a check valve in a pipe ?
Can we put a self-piercing valve on hot water ?
How to put a valve without cutting the water ?
How to change a valve gasket ?

Links suggested by Google